 engine tin not fitting close to the engine bay seal, Am I doing something wrong? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| buck toenges |
 Dec 11 2018, 01:19 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 553 Joined: 25-November 03 From: Fort wayne In Member No.: 1,388 Region Association: None 
 |
There is a gap between the front engine bay seal and the engine tin. The engine bay seal is new. Is this gap o.k.? Do I have to do something to make it fit better?
 Thanks, Buck |
   |
 
|
  |
Replies
| porschetub |
Dec 12 2018, 01:41 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 4,728 Joined: 25-July 15 From: New Zealand Member No.: 18,995 Region Association: None |
No that seems to be wrong,you should have to pull the top lip of the rubber over the tin,however I have a six but the principle is the same for a good seal.
You are using the correct seal for that area ?. |
|
|
|
Posts in this topic
buck toenges engine tin not fitting close to the engine bay seal Dec 11 2018, 01:19 PM
dr914@autoatlanta.com the power plant will adjust a bit forward back and... Dec 11 2018, 01:37 PM DRPHIL914 is it just in the front? maybe new seals like Geor... Dec 11 2018, 01:59 PM BeatNavy I been running the last couple of years with a sim... Dec 11 2018, 02:30 PM TheCabinetmaker I'm looking on my phone, but that seal does no... Dec 11 2018, 04:34 PM rgalla9146 Have you had any reason to remove your outer front... Dec 11 2018, 04:36 PM rhodyguy Did you replace all 4 of the seals? You have to wo... Dec 11 2018, 05:00 PM IronHillRestorations The factory front and side seals are miter cut ver... Dec 11 2018, 07:37 PM Larmo63 Are you sure you don't have the seal installed... Dec 11 2018, 08:03 PM ndfrigi for me I think the lip of the rubber seal is what ... Dec 12 2018, 02:24 PM
Rob-O I’m with Curt and Larmo, something looks off to ... Dec 12 2018, 03:14 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2024 - 06:34 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.