Adventures in hardware cleaning, Who doesn't like a clean screw? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Adventures in hardware cleaning, Who doesn't like a clean screw? |
Chi-town |
Dec 18 2018, 08:50 PM
Post
#1
|
Senior Member Group: Members Posts: 850 Joined: 31-August 18 From: Disneyland Member No.: 22,446 Region Association: Southern California |
Last weekend I spent the morning with @bdstone914 , @ValcoOscar cleaning hardware with Oscar's ultrasonic cleaner and trying different chemicals.
It got me thinking that I want an ultrasonic cleaner so I started doing some research. Looks like for most automotive cleaning 40khz is the sweet spot. I ordered a DK SONIC 6L 180W 40khz Ultrasonic Parts Cleaner with Heater from Amazon. (ETA Thursday) Oscar used a solution made for ultrasonic cleaners Bruce likes Evaporust I'm partial to CLR The ultrasonic solution cleaned most of the grease and oil and minor corrosion but did not affect the zinc coating. A 50/50 mix of the ultrasonic solution and Evaporust cleaned oil and grease and moderate corrosion but took some of the zinc coating off. I played around with straight CLR today with different lengths of submersion. I found a short dip cleaned corrosion ok but not much affect on grease/oil. A long dip takes the rust and zinc plating off completely. Once my cleaner gets here I want to play with a diluted CLR and a citrus degreaser to see how it does. What are you guys using to clean hardware / brackets? Anyone using an ultrasonic cleaner? Tips / tricks? |
bbrock |
Dec 19 2018, 08:40 AM
Post
#2
|
914 Guru Group: Members Posts: 5,269 Joined: 17-February 17 From: Montana Member No.: 20,845 Region Association: Rocky Mountains |
I was using a Harbor Freight ultrasonic cleaner with 50/50 pinesol to clean hardware before it crapped out. Pinesol removes zinc. I also used a diluted Simple Green solution to clean plastic and rubber parts and it worked great. I started getting paranoid about the impact cleaning solutions may have on hydrogen embrittlement so have switched to using a tumbler, wire wheel, and blasting cabinet for cleaning parts. Like Mark said, the tumbler will remove plating but last week I picked up some rust remover resin at HF and it seems to be more gentle on finishes. All of my stuff is going out for replating so the zinc will come off one way or the other anyway, so I'm not worried about it.
BTW, if you have an HF ultrasonic cleaner, the weakness is that the control panel and circuit board are not very well sealed against moisture and are on front where liquid inevitably drips when removing the cover and the parts basket. The circuit board corroded on mine after just a couple months of use. |
Lo-Fi Version | Time is now: 6th June 2024 - 05:55 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |