 Fuel pump just quit |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| surfdogskier |
 Oct 26 2019, 11:51 AM
Post
#1
|
|
Member  Group: Members Posts: 164 Joined: 20-May 16 From: East TN Member No.: 20,019 Region Association: None  |
So I had everything working well on my carb conversion with the exception of the fuel pump which constantly ran unless I pulled the ground wire per SirAndys carb conversion write up.
Now my pump will not work at all. I direct wired it to the battery to see if the pump was good and it worked. I connected a 12 volt wire to my relay board at the black/red wire #13 connection and it worked. So no issue with the wire. However something on the relay board or relay prevents it from working when the key is turned on. I was going to wire it to the 2 other points on the relay board to get 12 volts (T4b and the #12 pin on the T12 connector). However, with the key turned on, I am not getting 12 volts to either of these. the T4b, I am getting 2 volts and the pin 12 on the T12 I am getting 4 volts. My only other option to get 12 volt power is to connect to my coil but I have read this is not a good idea. Looking for some guidance. Attached image(s) 
|
   |
 
|
Posts in this topic
rhodyguy With the key in the on position, do you have 12v a... Oct 26 2019, 12:03 PM
surfdogskier
With the key in the on position, do you have 12v ... Oct 26 2019, 12:31 PM lierofox
So I had everything working well on my carb conve... Oct 26 2019, 12:32 PM surfdogskier
So I had everything working well on my carb conv... Oct 26 2019, 12:33 PM surfdogskier I am not seeing any blown fuses under the dash or ... Oct 26 2019, 12:44 PM rhodyguy the last sentence has me confused. The stand alone... Oct 26 2019, 12:57 PM surfdogskier
the last sentence has me confused. The stand alon... Oct 26 2019, 01:03 PM lierofox
[quote name='rhodyguy' post='2757415' date='Oct 2... Oct 26 2019, 02:33 PM surfdogskier
[quote name='rhodyguy' post='2757415' date='Oct ... Oct 26 2019, 04:57 PM lierofox
Thanks for this image and info. I haven't se... Oct 26 2019, 05:18 PM Minerva's 914 RE: Fuel pump just quit Oct 26 2019, 01:11 PM Superhawk996
:rotfl: Well done! Oct 26 2019, 04:17 PM rhodyguy with the extra wire for power and the jumper groun... Oct 26 2019, 01:46 PM surfdogskier
with the extra wire for power and the jumper grou... Oct 26 2019, 02:14 PM porschetub Did you check the pump and power supply relays,rea... Oct 26 2019, 03:22 PM rhodyguy Are you sure the relay is good? Plug it in to a re... Oct 26 2019, 03:26 PM injunmort I would suggest getting rid all jumpers, grounds a... Oct 26 2019, 03:36 PM surfdogskier I swapped the relays around but there was no diffe... Oct 26 2019, 04:00 PM lierofox
I swapped the relays around but there was no diff... Oct 26 2019, 04:38 PM porschetub
I swapped the relays around but there was no dif... Oct 26 2019, 11:40 PM surfdogskier She now purrs like a kitten. Thank all of you fo... Oct 27 2019, 06:07 AM KELTY360
She now purrs like a kitten. Thank all of you f... Oct 27 2019, 02:34 PM surfdogskier
She now purrs like a kitten. Thank all of you ... Oct 27 2019, 06:42 PM lierofox The biggest point of caution I'd give for that... Oct 28 2019, 01:17 PM surfdogskier
The biggest point of caution I'd give for tha... Oct 28 2019, 01:55 PM 914_teener :thumbsup: :brain: :blowup: Oct 28 2019, 01:46 PM rhodyguy :blink: Oct 28 2019, 01:55 PM Rand I understand the hack to get by. I do that too. Bu... Oct 28 2019, 04:09 PM lierofox
I understand the hack to get by. I do that too. B... Oct 28 2019, 06:30 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 24th October 2025 - 05:56 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.