Can't find 4th gear, I no i put it in there Options

[Bruce Edge]

I can go in to all gears except 4th gear. Side shift, rebuilt, bench tested with all gears working properly. all new bushings from gear shift leaver back to side shift. after going thru the general set up for long shift rod(tube) gear leaver pinch bolt ect. Here is what i have found the problem to be so far(I think).
When going in to 4th gear the long shift tube rolls to the highest point where it goes through the motor mount bar. Well, the tube hits the top of the hole in the bar not letting the lever in the transmission come down far enough. All new motor mounts were install.
So, do I raise the mount bar on the left side to see if that helps, hone out the hole in the mount some. I know all this rambling may not make sense, but hoping someone that had the same experience would pick up on what I was trying to say.
Any pointers is greatly appreciated.

Thanks,
Bruce

[porschetub]

I can go in to all gears except 4th gear. Side shift, rebuilt, bench tested with all gears working properly. all new bushings from gear shift leaver back to side shift. after going thru the general set up for long shift rod(tube) gear leaver pinch bolt ect. Here is what i have found the problem to be so far(I think).
When going in to 4th gear the long shift tube rolls to the highest point where it goes through the motor mount bar. Well, the tube hits the top of the hole in the bar not letting the lever in the transmission come down far enough. All new motor mounts were install.
So, do I raise the mount bar on the left side to see if that helps, hone out the hole in the mount some. I know all this rambling may not make sense, but hoping someone that had the same experience would pick up on what I was trying to say.
Any pointers is greatly appreciated.

Thanks,
Bruce

Are you sure the shift rod is installed right on the coupling,have you re adjusted the shifter after new mounts fitted? good luck.

[Bruce Edge]

I can go in to all gears except 4th gear. Side shift, rebuilt, bench tested with all gears working properly. all new bushings from gear shift leaver back to side shift. after going thru the general set up for long shift rod(tube) gear leaver pinch bolt ect. Here is what i have found the problem to be so far(I think).
When going in to 4th gear the long shift tube rolls to the highest point where it goes through the motor mount bar. Well, the tube hits the top of the hole in the bar not letting the lever in the transmission come down far enough. All new motor mounts were install.
So, do I raise the mount bar on the left side to see if that helps, hone out the hole in the mount some. I know all this rambling may not make sense, but hoping someone that had the same experience would pick up on what I was trying to say.
Any pointers is greatly appreciated.

Thanks,
Bruce

Are you sure the shift rod is installed right on the coupling,have you re adjusted the shifter after new mounts fitted? good luck.

Thanks for the input, I've checked and double checked for a week now. Ever gear shifts fine when driving the car except for going into 4th gear. I can disconnect the tube from the side shift on transmission and can put in to 4th with my hand with out any problem. I'll start again in the morning, was just thinking someone else had run in to this before.
Thanks again,