Welding on a fender - bodywork Q, McMark......and body gurus |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Welding on a fender - bodywork Q, McMark......and body gurus |
Aaron Cox |
Dec 12 2004, 09:14 PM
Post
#1
|
Professional Lawn Dart Group: Retired Admin Posts: 24,541 Joined: 1-February 03 From: OC Member No.: 219 Region Association: Southern California |
i need to pull a mcmark and section on a new fender... it was curled in heavil at the bottom by the door.... and a low spot above the wheel arch. PO bondo'd crap out of it.... i want to cut it off and weld on a new section....
urgerboy.....lend me your brain |
Aaron Cox |
Dec 14 2004, 01:17 PM
Post
#2
|
Professional Lawn Dart Group: Retired Admin Posts: 24,541 Joined: 1-February 03 From: OC Member No.: 219 Region Association: Southern California |
QUOTE(Eric_Shea @ Dec 14 2004, 12:15 PM) Basically... but leave the base metal w/o holes so you have a foundation for the rosette. roger that. now, how hard is it to set doorgaps and alignment before welding? clamp in place ...adjust and weld? |
Lo-Fi Version | Time is now: 16th June 2024 - 02:46 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |