 Rust inhibitors / converters / paints, What is the best surface preparation before painting |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Dobbsy |
 Jul 8 2020, 01:59 PM
Post
#1
|
|
Newbie  Group: Members Posts: 49 Joined: 22-May 14 From: West Midlands Member No.: 17,382 Region Association: England 
 |
Hello,
I have taken the fuel tank out to clean and under the tank there is surface rust which I would like to address before putting the tank back in. The goal is to clean it up and prevent the rust getting worse. I am think of using Kurust after I cleaned the majority of the rust off then paint over it. Are there any other products you could recommend.  Also how did the factory fit the roll bar, the PO did not do a good job of cutting the body to make way for the plate. |
   |
 
|
  |
Replies
| Amphicar770 |
Jul 8 2020, 03:48 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,195 Joined: 20-April 10 From: PA, USA Member No.: 11,639 Region Association: MidAtlantic Region
|
As others have said. You need to clean it to bare metal then epoxy primer. There are no miracle sealers for rust no matter what some products claim.
|
|
|
|
Posts in this topic
Dobbsy Rust inhibitors / converters / paints Jul 8 2020, 01:59 PM
dlee6204 My method for treating rust is wire wheel, ospho, ... Jul 8 2020, 02:07 PM
Costa05
My method for treating rust is wire wheel, ospho,... Jul 8 2020, 07:02 PM
Tdskip
My method for treating rust is wire wheel, ospho,... Jul 12 2020, 05:51 PM rjames Paints don't usually convert, they attempt to ... Jul 8 2020, 03:34 PM IronHillRestorations I do soap and water, solvent cleaner, abrasive of ... Jul 8 2020, 06:37 PM cali914
I do soap and water, solvent cleaner, abrasive of... Jul 9 2020, 07:46 AM Montreal914 This is an interesting topic;
As the OP shows his ... Jul 8 2020, 07:03 PM Costa05
This is an interesting topic;
As the OP shows his... Jul 8 2020, 10:21 PM Superhawk996
For the house garage type of repairs on a daily... Jul 13 2020, 06:09 AM bbrock
For the house garage type of repairs on a dail... Jul 13 2020, 07:38 AM Dobbsy Tomorrow I will go to the local body shop supplies... Jul 9 2020, 01:48 PM racingredsc IronHillRestoratios gets it right. Jul 12 2020, 05:03 PM Dobbsy Although I have a compressor I went for the epoxy ... Jul 13 2020, 09:45 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st May 2024 - 09:53 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.