 914Rubber Speaker Pods |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| sjhenry1075 |
 Jan 13 2021, 01:22 PM
Post
#1
|
|
Member  Group: Members Posts: 270 Joined: 22-July 12 From: Stevensville, MD Member No.: 14,709 Region Association: North East States 
 |
Hey everyone. Happy New Year! So is everyone else spending their stimulus on their 914's?
To anyone else who has purchased the speaker pods from 914rubber, what is the best way to cut out the center portion of the pod? |
   |
 
|
  |
Replies
| lierofox |
Jan 13 2021, 03:27 PM
Post
#2
|
|
Member Group: Members Posts: 256 Joined: 23-June 15 From: Paso Robles, CA Member No.: 18,880 Region Association: Southern California
|
For mine I measured the speaker's lip dimensions, then marked and drilled a hole in the center of the opening in the pod for a pivot, and used a dremel with a circle cutting jig. The ones I got were the fiberglass ones though, not the ABS plastic.
|
|
|
|
Posts in this topic
sjhenry1075 914Rubber Speaker Pods Jan 13 2021, 01:22 PM
Chris914n6 It's ABS so anything, but watch the heat as it... Jan 13 2021, 01:33 PM
sjhenry1075
It's ABS so anything, but watch the heat as i... Jan 13 2021, 01:45 PM Mikey914 They will cut the same, and the ABS will not leave... Jan 14 2021, 02:34 AM sjhenry1075
They will cut the same, and the ABS will not leav... Jan 14 2021, 07:25 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th December 2025 - 02:52 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.