914 GT Door Handle Pull Straps Options

[JamesJ]

Hello All,
Has anyone used these "GT door handle pull straps" from Auto Atlanta?
I removed the armrest/compartment assemblies as I wanted a clean and simple look on this car. I bought a set of the these and prior to installing them(still figuring out the best way to do that), I rotated the handle that pivots on the mounting tabs back and forth. They only freely pivot about 45 degrees, then they fight you, but perhaps once mounted they will pivot more fully or maybe they are not meant to pivot a full 90 degrees. I "bench tested" them by just pressing the mounting tabs against a flat surface and I found that the 45 degree position is enough to get 3 or 4 fingers behind it to pull on it.
The other issue is that they don't pivot back into the flat resting position because they are not spring loaded, so it appears that they will always be in the "open" position(see 2nd photo) and not sit against the door panel when not in use(I think I am ok with that); however, I am reluctant to put holes in my new door panels without knowing these will function well. I wish they were more sturdy than they are, but perhaps I am expecting too much from a $23 part.
Could anyone share how these have worked for them or if there is another similar alternative? Perhaps from a 911/912 application or other European car model?
Thanks!

[mepstein]

There are a couple sellers for the plastic ones on ebay.

WEVO aluminum are pricy but nice.

https://www.wevo.com/Products/BodyTrimProdu...RLiteHandle.htm

[JamesJ]

There are a couple sellers for the plastic ones on ebay.

WEVO aluminum are pricy but nice.

https://www.wevo.com/Products/BodyTrimProdu...RLiteHandle.htm

Thanks @mepstein
Those look great. Pricey, yes. WEVO is 15 minutes from my office. I can also start with the plastic ones and see how they hold up. I like that he WEVO handles mount in the same place as the plastic ones, so it’s easy to upgrade without cutting new holes in the door panels.

[mepstein]

There are a couple sellers for the plastic ones on ebay.

WEVO aluminum are pricy but nice.

https://www.wevo.com/Products/BodyTrimProdu...RLiteHandle.htm

Thanks @mepstein
Those look great. Pricey, yes. WEVO is 15 minutes from my office. I can also start with the plastic ones and see how they hold up. I like that he WEVO handles mount in the same place as the plastic ones, so it’s easy to upgrade without cutting new holes in the door panels.

The more knowledgeable guys on this site will know but I think the plastic and metal door pulls are just copies of an early Fiat door handle. I have seen some similar ones on ebay for reasonable prices. They are metal so that's a bonus over the plastic reproductions but I remember them being a gold color.

Lastly, someone on Pelican was making GT/RS door pulls in titanium. They looked fantastic but were $150-175pr iirc.