 40 or 44 IDF Webers, size matters |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 930cabman |
 Apr 14 2021, 05:00 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 4,572 Joined: 12-November 20 From: Buffalo Member No.: 24,877 Region Association: North East States 
 |
We are converting a stock 2 liter 4 cyl from D jet to Webers. My gut is telling me a 40 IDF with 32mm venturis is the correct starting point. I am considering purchase of a complete set of 44 IDF's, but are unable to locate 32 mm venturis. Assuming 32MM venturis can be found are 44 IDF"s too large for a stock 2 liter?
thank you |
   |
 
|
  |
Replies
| Racer |
Apr 15 2021, 07:50 AM
Post
#2
|
|
Senior Member Group: Members Posts: 787 Joined: 25-August 03 From: Northern Virginia Member No.: 1,073 Region Association: MidAtlantic Region |
I ran 40's on a "stock" 1.7 and the same 40's on a 2056. As mentioned, 44's would be better on a higher revving race motor / race cam or larger displacement motor.
|
 |
|
Posts in this topic
930cabman 40 or 44 IDF Webers Apr 14 2021, 05:00 PM
nditiz1 40 IDFs are best, but 44s will work if you choke t... Apr 14 2021, 05:11 PM barefoot Question: is the diameter air the manifold interf... Apr 14 2021, 05:17 PM johnhora 930cabman...
what's wrong with the stock D-Je... Apr 14 2021, 05:38 PM
930cabman
930cabman...
what's wrong with the stock D-J... Apr 14 2021, 06:06 PM brant
930cabman...
what's wrong with the stock D-... Apr 14 2021, 09:01 PM 930cabman
[quote name='930cabman' post='2908097' date='Apr ... Apr 15 2021, 05:02 AM Superhawk996
When operating correctly the Bosch system is far ... Apr 15 2021, 05:42 AM brant
1985 Alfa spider, maybe it was L jet, but very si... Apr 15 2021, 08:58 AM roblav1 At what what RPM is max HP? I'll take a swag ... Apr 14 2021, 06:15 PM 930cabman This is a stock 2 liter 4 cylinder engine. my gut ... Apr 14 2021, 06:19 PM roblav1 My 5800 rpm swag was off. My 914 spec says max hp... Apr 14 2021, 06:27 PM 930cabman
My 5800 rpm swag was off. My 914 spec says max h... Apr 14 2021, 06:40 PM type2man I would run 44 Webers. Personally I run 45 dells o... Apr 14 2021, 06:36 PM IronHillRestorations You want 40's. With that engine the vacuum si... Apr 14 2021, 07:11 PM Root_Werks
You want 40's. With that engine the vacuum s... Apr 15 2021, 09:29 AM johnhora OK so you have:
Stock 2.0L type 4 with stock FI ca... Apr 14 2021, 07:20 PM johnhora CB Performance's Bob Tomlinson's' book... Apr 14 2021, 07:29 PM 930cabman For me, it comes down to simple.
Bolt on carbs, ... Apr 15 2021, 05:46 AM nditiz1 Simplicity for me too. I worked with the black ma... Apr 15 2021, 06:11 AM VaccaRabite When I had my 2056 carbed I tried 44s and 40s.
Th... Apr 15 2021, 07:02 AM 930cabman
When I had my 2056 carbed I tried 44s and 40s.
T... Apr 15 2021, 07:27 AM Tdskip For 90% of your driving throttle response matters ... Apr 15 2021, 08:26 AM ClayPerrine I am on the side of Fuel Injection.
I have run ... Apr 15 2021, 12:19 PM 930cabman It's looking like D jet might be winning.
Fi... Apr 15 2021, 12:49 PM 930cabman I committed to D jet, sending the ECU to Module Ex... Apr 16 2021, 01:08 PM ClayPerrine
I committed to D jet, sending the ECU to Module E... Apr 16 2021, 01:11 PM 930cabman
I committed to D jet, sending the ECU to Module ... Apr 16 2021, 03:08 PM bbrock
I committed to D jet, sending the ECU to Module E... Apr 16 2021, 01:52 PM Superhawk996
I committed to D jet, sending the ECU to Module E... Apr 17 2021, 08:13 AM bbrock I've gotten the impression from reading variou... Apr 17 2021, 08:36 AM Superhawk996
I've gotten the impression from reading vario... Apr 17 2021, 08:52 AM 930cabman Yes, I have gathered the same, these rarely fail, ... Apr 17 2021, 01:05 PM stownsen914 I didn't read the whole thread, but my experie... Apr 17 2021, 04:48 PM 930cabman
I didn't read the whole thread, but my experi... Apr 17 2021, 05:21 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 05:19 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.