 crank shaft end play, Lots of assembly lube on trust bearing (NEED ADVICE) |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rfinegan |
 Apr 24 2021, 09:33 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,130 Joined: 8-February 13 From: NC Member No.: 15,499 Region Association: MidAtlantic Region 
 |
Hi World,
I added the shims to my 2056 I took out of the engine to get a base line. Same crank and shims but new bearings. So cleaned the shims and installed new Flywheel WO seal and clean shims. tight or just right? Do I hose the lube out with brake clean( dry bearing)? https://www.youtube.com/watch?v=QiM03KJbUhk Please advise -Best Robert |
   |
 
|
  |
Replies
| rfinegan |
Apr 24 2021, 12:40 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,130 Joined: 8-February 13 From: NC Member No.: 15,499 Region Association: MidAtlantic Region
|
@mark henry and All,
I swiped around some shims and got the familiar clunk now... will post the http://www.914world.com/bbs2/index.php?sho...51117&st=80 thread best regards -Robert |
|
|
|
Posts in this topic
rfinegan crank shaft end play Apr 24 2021, 09:33 AM
Mark Henry Tolerance is .003 to .006"
Lube shouldn't... Apr 24 2021, 10:05 AM iankarr Mark is the man.
I can't tell in this video ... Apr 24 2021, 11:17 AM Montreal914 I thought I remember doing this by hand, no prying... Apr 24 2021, 11:31 AM barefoot I had inconsistent results with lube on the flywhe... Apr 24 2021, 12:42 PM
rfinegan Yep that was part of it...much better now..thanks ... Apr 24 2021, 12:56 PM Mark Henry I use the feeler gauge type, I found it's ju... Apr 24 2021, 03:41 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th November 2025 - 07:00 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.