Exhaust Stud not Holding in Crankcase |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Exhaust Stud not Holding in Crankcase |
RestoReese |
May 10 2021, 02:05 AM
Post
#1
|
Newbie Group: Members Posts: 31 Joined: 29-June 19 From: Dallas, TX Member No.: 23,256 Region Association: Southwest Region |
As title says, I have an exhaust leak because one of my stud holes in the case is stripped and will not hold. Tried loctite red, but didn't hold with tightening. Also, wasn't sure it would hold with the heat. Thought about JB weld but then reconsidered.
I know I can tap to a larger diameter but wondering if others have had a similar issue and what you would recommend. Any guidance would be helpful. Case is for 1971 1.7L. |
Shivers |
May 10 2021, 08:10 AM
Post
#2
|
Senior Member Group: Members Posts: 2,430 Joined: 19-October 20 From: La Quinta, CA Member No.: 24,781 Region Association: Southern California |
The time-sert is a bit more work, and more expensive. You'll need to get the kit with proper installation tools. But, for me it was never an issue again.
|
Lo-Fi Version | Time is now: 9th June 2024 - 12:14 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |