 She lists to Port in rear, Suspension height difference |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Gatornapper |
 Jul 2 2021, 09:06 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,274 Joined: 22-September 17 From: Woods west of Richmond, VA Member No.: 21,449 Region Association: South East States 
 |
One of the first thing I noticed when I picked up my sweet barn find 914 4 years ago was a height difference in the rear (only) - she lists to port by 1/2".
I have the service record from the local Porsche dealer that about 3,000 miles prior to my getting the car, their shop had replaced the left rear trailing arm bushings. In working extensively on my 14 for the last 4 years (my shop has a lift), I can find no cause for the 1/2" height difference in the body at the rear axle center. Car had 60k original miles when I got it, now 63,600. I believe rear spring/shocks are original, and show no issues. Any help would be appreciated as to cause and fix for the list. TIA, GN |
   |
 
|
  |
Replies
| dr914@autoatlanta.com |
Jul 2 2021, 03:45 PM
Post
#2
|
|
914 Guru Group: Members Posts: 8,185 Joined: 3-January 07 From: atlanta georgia Member No.: 7,418 Region Association: None |
jack the front slightly from the center of the cross member to take most of the weight off of the front (do not have to lift the tires off of the ground) and see if the rear straightens out. If so the front torsion bars are out of adjustment
|
|
|
|
| Gatornapper |
Jul 3 2021, 08:18 PM
Post
#3
|
|
Senior Member Group: Members Posts: 1,274 Joined: 22-September 17 From: Woods west of Richmond, VA Member No.: 21,449 Region Association: South East States
|
George -
Thank you so much. Will do. I haven't noticed any difference in the front, but now that you suggest the problem might be there, I'll measure that too - Not quite sure I know where I should jack from - don't remember a cross member up front - but then I was never looking for one.....I'll find it I'm sure. As always, appreciate the wisdom. GN QUOTE(dr914@autoatlanta.com @ Jul 2 2021, 03:45 PM)  jack the front slightly from the center of the cross member to take most of the weight off of the front (do not have to lift the tires off of the ground) and see if the rear straightens out. If so the front torsion bars are out of adjustment |
|
|
|
Posts in this topic
Gatornapper She lists to Port in rear Jul 2 2021, 09:06 AM
mepstein Every 914 I've purchased with original shocks ... Jul 2 2021, 09:15 AM mrholland2 Is "port" on a car left or right? :) Jul 2 2021, 10:35 AM
VegasRacer
Is "port" on a car left or right? :)
T... Jul 2 2021, 10:40 AM barefoot Previous owner (before you) must have been quite h... Jul 2 2021, 11:59 AM Al Meredith Should say "aft " instead of rear. 50 ye... Jul 2 2021, 02:34 PM 73-914
Should say "aft " instead of rear. 50 y... Jul 2 2021, 08:34 PM euro911 Should say "aft " instead of rear. 50 ye... Jul 3 2021, 01:49 AM worn
Should say "aft " instead of rear. 50 ... Jul 4 2021, 05:49 PM zipedadoo Mine did the same thing. I put on new springs, new... Jul 2 2021, 02:52 PM partwerks
jack the front slightly from the center of the cr... Jul 2 2021, 08:19 PM zipedadoo
jack the front slightly from the center of the c... Jul 3 2021, 07:24 AM infraredcalvin
jack the front slightly from the center of the c... Jul 3 2021, 08:45 AM Gatornapper George, et al -
Sure nuf. Left front is 3/8... Jul 4 2021, 07:00 PM Gatornapper George -
Thank you again for your perfect analysi... Jul 14 2021, 04:08 PM Superhawk996 :agree: as a 1st step.
Unless you measured the r... Jul 2 2021, 04:05 PM Front yard mechanic Get a fat girl friend and drive on bumpy roads :c... Jul 2 2021, 09:20 PM Gatornapper FRM -
Like the girl I've had for 48 years and... Jul 3 2021, 08:21 PM bdstone914 @Gatornapper
Hopefully it is a spring or bushing... Jul 3 2021, 09:25 AM sixnotfour Depending on Ballast (you) might want to raise the... Jul 4 2021, 07:06 PM Gatornapper I'm 179 lbs. Think the xtra is probably not n... Jul 7 2021, 08:18 AM Gatornapper FYI -
Instructions on how to correctly set the fr... Jul 8 2021, 03:54 AM barefoot
FYI -
Instructions on how to correctly set the f... Jul 14 2021, 04:28 PM Gatornapper Yes, they are a bit munged up for some reason........ Jul 15 2021, 08:08 AM JamesM
I have the service record from the local Porsche ... Jul 7 2021, 09:55 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th July 2025 - 12:27 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.