FS: 1.7/1.8/2.0L SSI Stainless Steel Heat Exchanges & Bursch Turbo Quiet Muffler Options

[saladin]

Selling a used set of 2.0L SSI stainless steel exhaust manifold & heat exchangers and a used Bursch Turbo Quiet muffler. I am converting to a six so these must go.

SSI Stainless Steel Heat Exchanges: New Cost - $2,058, Selling for - $1,200
Additional information available at Pelican Parts.

Bursch Turbo Quiet Muffler: New Cost - $520, Selling for - $200
From the manufacturer: Flanged collector with Turbo Quiet Muffler that is mandrel bent from 16 gauge steel for durability and merged for smooth flow. Designed, tested, and built to the finest hand-made integrity found in any exhaust system. Mufflers come with Polished Chrome Exhaust Tip. Bursch Turbo Quiet Mufflers features unrestricted max-flow straight-through design Dyno proven to flow up to 2,000 SCFM and support up to 2,000 horsepower. Each muffler has Continuous Roving Fiberglass (CRF) technology to absorb unwanted interior resonance while maintaining a performance turbo hush tone.

See the below photos to understand their condition. Local delivery is preferred and available within a 45-minute drive from the I-280/Highway 85 interchange in Silicon Valley California. However, shipping arrangements can be made at an additional cost and time for secure packing.

The exhaust manifold & heat exchangers are made to fit 1973/74 model years with a 2.0L; however, they can be installed on other model years and engines by installing a 1973/74 2.0L muffler bracket as shown in this Pelican Parts forum topic, corresponding muffler, and the correct warm air guides for 1975/76 model years.





















Thanks,

Ken

[rhodyguy]

When back dating 75-76 HEs you will also need the correct warm air guides. The dr side version is dependent on SS or TS transmissions.