What HP level requires transmission upgrades?, I have 200 HP to the wheels, what do I need? Options

[FourBlades]

I realize it is probably torque that kills a transmission, but I don't know the torque output of my engine.

I am building a 901 transmission for my IMSA 914 and wonder what upgrades it will need. I have some possible upgrades I could do now.

First, I have a set of 930 stub axles, CVs and the corresponding sway-away axles for a 914. They are stronger and the CVs are available for $80 from pelican. Downside is I have to destroy the existing rear bearings in my axles to use them, which were rebuilt by PMB.

If I have 200 HP to the wheels are the 930 CVs a necessary or worthwhile upgrade?

Second, should I upgrade to the billet intermediate plate at this HP level?

If I do, will I have to reset the pinion depth? That is something I can't do myself and would need to find a shop here in Florida that can do it. I know this is overkill for a typical 914, but with 12 inch rear tires and a 2.5L six, is this when the upgrade is worth while?

I am not adverse to starting with the 914 axles and upgrading down the road. Pulling the engine and transmission is not that time consuming. I would hate to break the smaller axles or CVs the first time at the track though.

I have a stock gearset and know there are probably better gear choices for Sebring, Daytona, etc. No idea where to start with those.

I will be running a transmission cooler to start and may move to gear set spray bar over time. I have read that the mesh point of the gears is where to aim the cool oil sprays, not sure this is correct.

I appreciate any advice people have.

John

[brant]

A 914 race builder out here…. Recommends 205hp as the division between the 914 / 916 trans

I would blow my trans every other year without cooling
I added the intermediate plate and cooling after 4 rebuilds
Now 4 seasons on that box
And I’m Under 200 horse