Firewall tips, Dealing with the tubes |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Firewall tips, Dealing with the tubes |
obscurity |
Jan 2 2022, 05:08 PM
Post
#1
|
Member Group: Members Posts: 411 Joined: 24-February 06 From: Atlanta ,GA Member No.: 5,628 Region Association: South East States |
I am in the process of cutting out the rear fire wall for replacement as it was rusting along the bottom edge and and in poor condition at the bottom of the cluster of tube and cable holes. What is the best approach to removing the metal around the tubes? Do folks generally replace the tubes or try to save them. The portion in the tunnel that I can see looks ok but I have not yet taken the floor off so they could be bad further up.
Thanks, John |
Superhawk996 |
Jan 3 2022, 10:17 AM
Post
#2
|
914 Guru Group: Members Posts: 5,904 Joined: 25-August 18 From: Woods of N. Idaho Member No.: 22,428 Region Association: Galt's Gulch |
Photo is a bit vague.
You should be able to keep the tubes assuming they aren't rotted. Looks like you bought a patch panel but for some reason already cut it to exclude the tubes? I'd just use that section of the new panel and "key" the holes so that you can get sections of the panel around the flared tubes. Tubes are brazed. Do not weld them or you risk having weld penetration into the ID of the tube. |
obscurity |
Jan 3 2022, 12:13 PM
Post
#3
|
Member Group: Members Posts: 411 Joined: 24-February 06 From: Atlanta ,GA Member No.: 5,628 Region Association: South East States |
Photo is a bit vague. You should be able to keep the tubes assuming they aren't rotted. Looks like you bought a patch panel but for some reason already cut it to exclude the tubes? I'd just use that section of the new panel and "key" the holes so that you can get sections of the panel around the flared tubes. Tubes are brazed. Do not weld them or you risk having weld penetration into the ID of the tube. Thanks, I did cut the panel so I could get it on both heater tubes. The photo does not show it well but the bottom edge of the panel is not in great shape as it is heavily pitted form the back so there is a lot less metal then it appears. I will try fishing the tubes through as you suggest. Good info on the brazing though and would probably explain the yellow metal I keep finding. I have never brazed... I guess I get to learn a new skill |
Lo-Fi Version | Time is now: 11th June 2024 - 11:21 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |