 Trunk adjustment, One side higher than other |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Robarabian |
 Jan 25 2022, 10:37 PM
Post
#1
|
|
914 A Roo  Group: Members Posts: 687 Joined: 11-February 19 From: Simi Valley, Kalifornia Member No.: 22,865 Region Association: Southern California 
 |
How do I adjust this so it is even. The hinges all work great and are not cracked / fractured. After my repaint I mounted everything but one side is off.
Is it the adjustment of the hinge hardware (all the little brackets / washers?) Any help is appreciated.  |
   |
 
|
  |
Replies
| Superhawk996 |
Jan 26 2022, 02:49 PM
Post
#2
|
|
914 Guru Group: Members Posts: 7,030 Joined: 25-August 18 From: Woods of N. Idaho Member No.: 22,428 Region Association: Galt's Gulch
|
Could be a lot going on there.
Assuming trunk hinges are in the right location . . . does it fit better with a gentle twist? Hard to tell from picture is this all lined up along all other sides but this is just excessive gap in Z height? Do you have the seals in there? Is one side seal sitting tall, holding up the right side? Not sure what you mean by "all the little brackets". The little 2nd leg that extends down to the wheelhouse doesn't control Z height. Did it fit properly before paint? |
 |
|
Posts in this topic
Robarabian Trunk adjustment Jan 25 2022, 10:37 PM
Robarabian bump Jan 26 2022, 02:38 PM Olympic 914 Do you have the rubber adjusting nubs in the corne... Jan 26 2022, 04:54 PM Mikey914 Well, looks like trunk lock not installed. I suspe... Jan 26 2022, 05:11 PM rhodyguy Good eye Mark. Totally missed it. Jan 26 2022, 05:40 PM bkrantz If all the stuff mentioned above checks out, and i... Jan 26 2022, 08:29 PM Robarabian Thanks everyone. Yes I installed the rubber seal. ... Jan 26 2022, 09:37 PM
76-914 Luv that color! :beer2: Jan 26 2022, 10:34 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 07:56 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.