 Rubber Replacents, Finally done ! How I did it …. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jim_hoyland |
 Mar 14 2022, 11:12 AM
Post
#1
|
|
Get that VIN ?  Group: Members Posts: 9,818 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California 
 |
Before I replace the targa top and door piller rubbers, I need to review the ins/outs of this. Seems like there’s a good thread How To do this……
@Mikey914 |
   |
 
|
  |
Replies
| jim_hoyland |
Mar 14 2022, 07:11 PM
Post
#2
|
|
Get that VIN ? Group: Members Posts: 9,818 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California
|
The AA website gives this installation instruction “ easily replaced with a wide blade screw driver and some silicone grease just fit the inner side into the channel and then pinch the outside in with a screwdriver. remember not to cut it short as it will shrink to fit! direly needed to seal the wind and water out of your 914 “
Do I fit thr inner edge first or outer edge ? @Mikey914 |
|
|
|
Posts in this topic
jim_hoyland Rubber Replacents Mar 14 2022, 11:12 AM
Mikey914 Targa roof to window seal-
The biggest problem I s... Mar 14 2022, 11:39 AM jim_hoyland Thanks :) Vertical seals went in easy; haven’t... Mar 14 2022, 12:02 PM jim_hoyland I’m doing the top seal. Forcing the seals inner ... Mar 14 2022, 01:56 PM Mikey914 Yes it is a pain, but you can see how it retains t... Mar 14 2022, 02:12 PM jim_hoyland Gave up today; the fit is just too tight. I’ve d... Mar 14 2022, 02:22 PM fsh2liv Targa seal. Nice product but a pain to install. W... Mar 14 2022, 10:03 PM Mikey914 Re read my post. The warm soapy water will make ma... Mar 15 2022, 10:03 AM jim_hoyland It took two sets of hands to get to the side targa... Mar 16 2022, 04:50 PM Mikey914 Thanks Jim,
The cutting is where the cuts like but... Mar 16 2022, 05:19 PM
Robarabian I have to do this soon. Thanks for the tips Jim... Mar 16 2022, 08:34 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th July 2025 - 11:16 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.