Need Carb Jet Guidance, Weber 40 IDFs Options

[bbrock]

Plans to Megasquirt my car got delayed over the winter so my Webers will stay on for another summer. So, I finally hooked up my wideband to see if any adjustments are needed to keep the engine happy and safe until I can do the conversion.

The only real "problem" area is idle and low speed driving on the progression circuit where it is running too rich. It idles smooth and steady at 700 rpm with AFR of 12.3. That with idle mix screws ~ 2 turns off their seats. That's the leanest I can adjust and keep the engine happy. Just off idle at 20-40 mph @3000 rpm it goes even more rich to around 11.0 +/- 0.5. I don't think that's alarmingly rich but wasteful and I do get a bit of annoying surging/bucking driving below 30 mph.

Current jetting is as follows:

Venturi - 28
Emulsion tubes - F11
Main jet - 115
Correction Jet - 200
Idle jet - 50

I'm thinking I should reduce the idle jet but not sure by how much. I can get .047, .045, or .040. Any suggestions?

I could also use some advice on mains and/or air correction jets. If I didn't plan to swap the carbs to FI, I'd try for a little leaner highway cruising mix for better economy and maybe flexibility. In limited testing running in good ranges for performance at the expense of economy - WOT ~12.5, Highway cruise ~13.5 but rarely goes above 14.0 even on downhill and decel. Weather is crappy here this weekend so I've only done a short drive in hilly conditions. I need to get it down in the valley for some long level runs to see where it settles. I think I can live with the numbers I'm seeing now, but do wonder what it will do when I attempt to cross a 10,000 ft. pass. I'd rather it not die of oxygen starvation if I attempt it. Any thoughts?

BTW, I live at 6,000 ft. elevation so I'm not surprised it is running on the rich side with out of the box jetting.

[nditiz1]

Just ordered 2 of those colortune's last week. Hopefully they will be here soon. @infraredcalvin how was it tuning the banks with it?

[infraredcalvin]

Just ordered 2 of those colortune's last week. Hopefully they will be here soon. @infraredcalvin how was it tuning the banks with it?

Totally worth the cost, the piece of mind is great. It’s a bit awkward the first time, but when you get them all dialed in you notice things are better balanced.

@nditiz1 There seems to be a pretty good range of “blue” light as you’re tuning, i set all mine just as it goes fat (orange) to blue, my wide band reads in the 11s, when I take it to the point just before it leans out (white), it reads 13/14s on the afr. Since I track my car, I’ve left it on the fat side for now.