 1.8 Injectors, 112 vs 102? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| StarBear |
 Aug 19 2022, 08:46 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,212 Joined: 2-September 09 From: NJ Member No.: 10,753 Region Association: North East States 
 |
A bit of a mystery about a set of four 1.8L injectors compared to known info. Known is VW/Bosch part 022906301C/0028150112, with spec of 18.1 lbs/hr or 190.2 cc/min. See top of pic (blue module).
This other set (bottom of pic gray module) has same VW number but has Bosch number 0028150102 (not 112); Mr Injector test results show 200 cc/min. Looks same as known. Can find no reference for a Bosch injector ending in 102. Questions: 1. Might the second set just be stamped wrong or are older, being superseded by 112? 2. Any undesirable or unwanted results from flow slightly higher than spec? Would it run rich? Way out of my wheelhouse here, so community experience and wisdom much appreciated!   |
   |
 
|
  |
Replies
| StarBear |
Aug 19 2022, 01:27 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 2,212 Joined: 2-September 09 From: NJ Member No.: 10,753 Region Association: North East States
|
Bill “Mr. Injector” informs me that the two are equivalent (hence same VW number).
@jeffbowlsby another 1.8 equivalent part number for your table? |
|
|
|
Posts in this topic
StarBear 1.8 Injectors Aug 19 2022, 08:46 AM
Van B Jeff's table is still the best reference tool ... Aug 19 2022, 08:55 AM
StarBear
Jeff's table is still the best reference tool... Aug 19 2022, 09:13 AM StarBear
Jeff's table is still the best reference tool... Aug 19 2022, 09:21 AM
fiacra
Jeff's table is still the best reference tool... Aug 19 2022, 02:00 PM Van B These systems aren't measuring resulting mixtu... Aug 19 2022, 11:37 AM StarBear
These systems aren't measuring resulting mixt... Aug 19 2022, 11:57 AM Van B I guarantee you that your old injectors are not sp... Aug 19 2022, 12:30 PM StarBear @ejm Ed; any insight or experience on this myste... Aug 19 2022, 01:19 PM wonkipop from my trusty aus site
https://aussieinjectors.c... Aug 19 2022, 01:44 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th November 2025 - 11:35 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.