 Targa Top Issues, Loose |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| NARP74 |
 Sep 5 2022, 08:52 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,370 Joined: 29-July 20 From: Colorado, USA, Earth Member No.: 24,549 Region Association: Rocky Mountains  |
I have noticed some creaking coming from the rear targa top area when I drive. I lifted up on all four corners of the top and the right rear is loose. Even when the top is latched, I can lift it up a bit. That is probably my issue, but what is the fix?
|
   |
 
|
  |
Replies
| bdstone914 |
Sep 5 2022, 07:41 PM
Post
#2
|
|
bdstone914 Group: Members Posts: 4,906 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
QUOTE(NARP74 @ Sep 5 2022, 07:52 AM)  I have noticed some creaking coming from the rear targa top area when I drive. I lifted up on all four corners of the top and the right rear is loose. Even when the top is latched, I can lift it up a bit. That is probably my issue, but what is the fix? @NARP74 Make sure you have the correct too. The rubber blocks for the early tops are shorter andcwider. A nickle will fit between the bumps on a late latch and a quarter is the width of the early latch. Compare that to the width of the rubber block tgat fits unto the top of the latch. |
|
|
|
Posts in this topic
NARP74 Targa Top Issues Sep 5 2022, 08:52 AM
jim_hoyland I recently went through the same thing,right rear ... Sep 5 2022, 09:57 AM NARP74 I keep hearing about the pad replacing being a tou... Sep 5 2022, 10:06 AM scallyk9 You can also slide a short length of plastic or ru... Sep 5 2022, 12:20 PM
FL000
You can also slide a short length of plastic or r... Sep 5 2022, 02:45 PM porschetub
I have noticed some creaking coming from the rear... Sep 5 2022, 02:59 PM jim_hoyland Yes the targa pad removal is a bear the first time... Sep 5 2022, 03:04 PM 914GTSTI Anybody tried using shrink tubing ? Sep 6 2022, 12:43 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 10:08 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.