Speed engine drop Options

[1bad914]

I'm pulling a 2.0 out of a trashed 76 914. I have everything disconnected accept the cv bolts, these are the toughest I've ever tried, I've used every trick I know and still can't get one to budge. The car is litterally folding in half, any ideas for dropping the motor with out have to loosen the cv bolts, if I can get it out I can get some leverage and get them out. The car is so bad that when I reef on the bolts the whole car flexes. I thought about cutiing the rear end of the car off and flipping it over, I even tried to cut the axle, no go! Those things are hard!!!!! (IMG:http://www.914world.com/bbs2/html/emoticons/sawzall-smiley.gif) Also, what is the size of the axle nut?

[michel richard]

Dropping the rear end should be fairly easy. The shock top nuts usually come out easy. The three bolts on the outboard ears of the radius arms will probably break, but that's not a problem since you're throwing the tub away. The big bolt at the inner end of the radius arm may well break too. It's a little harder to get to, and breaking those makes it hard to save the radius arm, but that's not too bad. You can also pop the sway bars fairly easily right at one of the "ball joints" on each side.

It would probably be best to ease the shock tops out of the towers before you start lowering the engine, because they have a tendency to get stuck.

I've never done it that way, but I have taken plenty of rusted cars apart.

Toughest I ever had to use for the cv bolts was to apply heat, then loose nut daily for a couple of days, then heat again then a combination of the 12 point tool and big vise-grips on the bolts.

Have you considered using a grinder to cut the bolts off ?

Just my .02

Michel Richard