 Engine shelf replacement-, Whole or part? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| seanpaulmc |
 Mar 11 2023, 07:26 PM
Post
#1
|
|
Member  Group: Members Posts: 382 Joined: 6-December 16 From: Orlando, FL Member No.: 20,649 Region Association: South East States 
 |
After the hell hole repair, I have the engine shelf to repair/replace. Question for those of you who have done this before, I’m trying to decide on splicing in a short repair section or trying to extract the remaining original panel and install the whole new RD panel. The latter being the most work.
Not a special car in terms of rarity, options, or other. Been doing lots of rust repair. Just not sure how to tackle it yet. Thanks   Look forward to hearing your feedback. |
   |
 
|
  |
Replies
| Dlee6205 |
Mar 11 2023, 08:04 PM
Post
#2
|
|
Member Group: Members Posts: 60 Joined: 9-December 22 From: Burnsville, NC Member No.: 27,017 Region Association: South East States |
I typically splice it right at the rear of the suspension ear but not the channel, I replace that fully.
|
|
|
|
| seanpaulmc |
Mar 11 2023, 08:54 PM
Post
#3
|
|
Member Group: Members Posts: 382 Joined: 6-December 16 From: Orlando, FL Member No.: 20,649 Region Association: South East States
|
QUOTE(Dlee6205 @ Mar 11 2023, 09:04 PM)  I typically splice it right at the rear of the suspension ear but not the channel, I replace that fully. Kind of what I was thinking to do. But how do you find the spot welds in the old channel to get it removed? |
|
|
|
Posts in this topic
seanpaulmc Engine shelf replacement- Mar 11 2023, 07:26 PM
914werke Done it both ways.
Actually there are 3 ways... C... Mar 11 2023, 07:57 PM
windforfun
Done it both ways.
Actually there are 3 ways... ... Mar 11 2023, 08:05 PM bkrantz I spliced a section of shelf, about where yours is... Mar 11 2023, 08:45 PM Dlee6205
I typically splice it right at the rear of the s... Mar 12 2023, 08:22 AM Ishley Just to be clear…
You don’t just replace the c... Mar 12 2023, 12:02 PM seanpaulmc
Just to be clear…
You don’t just replace the ... Mar 12 2023, 12:30 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 03:57 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.