 Metal flare locating question... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bossboy302 |
 Dec 9 2023, 03:15 PM
Post
#1
|
|
Member  Group: Members Posts: 88 Joined: 13-December 21 From: NorCal Member No.: 26,158 Region Association: None  |
Sorry if asked tons of times before...
How have you located the height of the AA metal GT flares? The lip at the bottom (which needs trimming)....to what area is this aligned with? The stock lower fender has several bends and bevels, the new flare is flat. I'll try and post a picture to help explain my question, but those of you who have done flares probably get what I'm asking here...(?) Thanks |
   |
 
|
  |
Replies
| bossboy302 |
Dec 10 2023, 11:01 AM
Post
#2
|
|
Member Group: Members Posts: 88 Joined: 13-December 21 From: NorCal Member No.: 26,158 Region Association: None |
Let me thank all who have shared info and pictures. Immensely helpful.
I have a diagram of the flare install with fore and aft dimensions and measurements (I think from Auto Atlanta). It's the height that was unclear, but now I see what (and how) has been done, and think I can move forward. Not sure how soon I'll get to it, but will post the first one and go from there. Again, thanks for all the help. Happy Holidays! |
|
|
|
Posts in this topic
bossboy302 Metal flare locating question... Dec 9 2023, 03:15 PM
mepstein Ben / @MB911 can probably explain it better than... Dec 9 2023, 04:33 PM tygaboy If it would help, you’re welcome to come over an... Dec 9 2023, 05:38 PM rick 918-S I use the longitudinal cover panel as a guide for ... Dec 10 2023, 08:29 AM mlindner Bossboy 302, I had mine welded on 35 years ago. I ... Dec 10 2023, 08:56 AM rgalla9146 I established the height by butting the horizontal... Dec 10 2023, 09:02 AM mlindner Found this. Dec 10 2023, 09:05 AM Shivers
If you can zoom in, I clamped a piece of angle ... Dec 10 2023, 10:03 AM Shivers RE: Metal flare locating question... Dec 10 2023, 10:06 AM Shivers
I cut the bottoms off and cut up 6”-8” on e... Dec 10 2023, 10:18 AM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th July 2025 - 12:22 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.