 Clutch Install Issues, Pressure plate not in contact with flywheel |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| RKramden |
 Dec 12 2023, 09:33 PM
Post
#1
|
|
Newbie  Group: Members Posts: 41 Joined: 26-October 19 From: So. California Member No.: 23,589 Region Association: Southern California  |
I am having issues with my new clutch. After tightening to torque (18fp) the pressure plate is still not in contact with the flywheel (aprox. 1mm gap). Is this normal? If not, should I continue to tighten until it bottoms on the flywheel?
When I first installed, it was almost a 1/4" gap at torque, so I put some clamps on it and I got the internals of the pressure plate to move that I now assume were somehow frozen. Any advice would be greatly appreciated.  |
   |
 
|
  |
Replies
| Shivers |
Dec 12 2023, 10:13 PM
Post
#2
|
|
Senior Member Group: Members Posts: 2,431 Joined: 19-October 20 From: La Quinta, CA Member No.: 24,781 Region Association: Southern California |
18 lbs is right. I wouldn’t go any more. If it was me, I’d pull it apart and see what is wrong. Are those bolts too long? @RKramden
|
|
|
|
Posts in this topic
RKramden Clutch Install Issues Dec 12 2023, 09:33 PM
Superhawk996
If it was me, I’d pull it apart and see what is... Dec 13 2023, 05:54 AM
ndfrigi Yes probably you have a longer bolts and I think n... Dec 13 2023, 01:13 AM burton73 Picture of bolts
Bob B
Dec 13 2023, 04:53 PM RKramden I will change the bolts once I get the tightening ... Dec 14 2023, 09:43 PM Shivers I do not have a flywheel to look at, it is on the ... Dec 15 2023, 11:51 AM RKramden Issue resolved with hex head bolts (fully threaded... Dec 15 2023, 06:14 PM Superhawk996 :trophy: good find
So which supplier did the fl... Dec 15 2023, 07:47 PM RKramden The flywheel came via a third party so I’m not s... Dec 16 2023, 09:59 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 07:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.