2270 Deck Height and CR, Pistons sitting proud of the deck, how many shims is too many shims? Options

[vjb206]

Hey folks! I have the bottom-end of my 2270 assembled and spinning freely. Thanks to all who helped me get to this point!

(IMG:http://www.914world.com/bbs2/uploads_offsite/media.giphy.com-23760-1708984357.1.gif)

To quickly recap: I bought the 2257 kit from AA Pistons (78mm stroke, 5.158" rods, etc.). And when I threw a P&C on for a test-fit last weekend, I immediately noticed the piston sitting proud of the deck height at TDC (negative deck) by about 2mm.

(IMG:http://www.914world.com/bbs2/uploads_offsite/media.giphy.com-23760-1708984358.2.gif)

Before I overreact, or buy the wrong stuff, I thought I'd ping the community...

1. Is this normal for a stroker set-up?
2. Can you stack multiple shims when getting up into the .06 >> .09 range?
3. (If no-stack) What's the best place to have custom shims cut?
4. I recall Jake saying using large shims requires lots of advance, anyone have experience here? What am I looking to adjust for upon start-up?

Once I figure out whether or not this is normal (I.E. verifying that I don't have to backtrack), I'll get into the CR questions (just waiting on clear plastic from Amazon so that I can measure my CC volume this weekend) (IMG:style_emoticons/default/biggrin.gif)

Thanks!

[Jack Standz]

There's more to the compression calculation and an engine build, but based on your #s, it's looking to be around 9.4. That might be high if you're looking to daily drive it and the car doesn't spend its days at high altitude.