Silverline bearing out of round |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Silverline bearing out of round |
cgnj |
Mar 6 2024, 08:56 PM
Post
#1
|
Senior Member Group: Members Posts: 623 Joined: 6-March 03 From: Medford, NJ Member No.: 403 Region Association: None |
Just spoke to machinist today. Bearing 4 out of round. These are Silverline bearings. I'm thinking time to go German.
Anyone else have a similar problem? |
cgnj |
Mar 7 2024, 09:23 AM
Post
#2
|
Senior Member Group: Members Posts: 623 Joined: 6-March 03 From: Medford, NJ Member No.: 403 Region Association: None |
More information
Case was checked for line bore and thrust. Saddles were not hammered. Bearing 4 would not fit over the journal out of the box. I was not confident of my results with micrometer and bore gauge. Case, crank and bearings went back to machinist. I expected that the bearing was mis-marked. In any case, I ordered a new set of bearings. I only spoke to him on the phone. Get more detail today when I stop by the shop. |
Lo-Fi Version | Time is now: 31st May 2024 - 08:29 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |