 Oil filler differences, Which to use? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| scrz914 |
 Jan 13 2025, 05:41 PM
Post
#1
|
|
Member  Group: Members Posts: 452 Joined: 21-April 04 From: Santa Cruz, CA Member No.: 1,960 Region Association: Central California  |
I have a couple of choices of oil fillers to use with my aftermarket oil tank. There are notable differences and I’m not sure why.
One is aluminum, the other steel. Overall length. The aluminum one is a bit longer which could make filling easier. But more intrusive. The vent hose sizing. Aluminum one is for 25mm hose the other is 13mm. I’m guessing they are designed to terminate at different devices? I’ve seen from diagrams that some end at an oil overflow bottle. Where did the hose end up on the original 914-6? Thanks for your help. Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| mb911 |
Jan 14 2025, 05:40 AM
Post
#2
|
|
914 Guru Group: Members Posts: 7,821 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest 
|
Btw why you really don’t want the vent to connect to the air filter is that when you accidentally overfill the tank and that’s a when as everyone has done it at least once or when you drive aggressively the excess oil gets consumed by the engine and you get a ton of smoke out the tail pipe which will also effect combustion effect and could be detrimental to the health of the engine especially if running full tilt. Stock -6 engines really were not high performance so didn’t really matter
Simple answer mine is designed for puke tank just like GTs The aluminum one designed for attaching to stock filter but could be adapted to puke tank. |
|
|
|
Posts in this topic
scrz914 Oil filler differences Jan 13 2025, 05:41 PM
Cairo94507 It's been a while since I owned a stock 6 but ... Jan 13 2025, 05:49 PM scrz914 I have a 3.0 sc motor. Trying to think where the T... Jan 13 2025, 06:14 PM Nate W You should use the one with the larger vent, the 2... Jan 13 2025, 10:08 PM
scrz914
You should use the one with the larger vent, the ... Jan 13 2025, 10:30 PM mb911 Mine is the one in the bottom of the picture. The ... Jan 14 2025, 05:34 AM Steve
Btw why you really don’t want the vent to conne... Jan 14 2025, 08:41 AM scrz914 Thank you. This information is very helpful. Jan 14 2025, 01:56 PM mb911
Thank you. This information is very helpful.
For... Jan 15 2025, 07:16 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd October 2026 - 04:20 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.