 TDC actual vs. mark on fan |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jmargush |
 Mar 16 2025, 06:20 AM
Post
#1
|
|
Member  Group: Members Posts: 484 Joined: 8-June 04 From: Goshen, IN Member No.: 2,176  |
Has anyone experienced the mark on the fan being off from where actual TDC is ?
Last time I had the engine out I put a dowel in cylinder #1 and found TDC and the factory mark was approx. 3/8" tot he left of where I feel TDC on #1 was. I am going to recheck it and see if I made an error the last time I did it. |
   |
 
|
  |
Replies
| jmargush |
Mar 16 2025, 01:36 PM
Post
#2
|
|
Member Group: Members Posts: 484 Joined: 8-June 04 From: Goshen, IN Member No.: 2,176 |
I just checked it with a dowel again.
What I think I am seeing is a bit of dwell at the top of the stroke. Dowel stops moving a bit before the factory mark on the fan. Once it moves past the factory mark the piston starts to travel downward again. Does this sound logical/possible? |
|
|
|
Posts in this topic
jmargush TDC actual vs. mark on fan Mar 16 2025, 06:20 AM
barefoot I've seen where the fan is displaced from inte... Mar 16 2025, 07:37 AM
930cabman
I've seen where the fan is displaced from int... Mar 16 2025, 07:39 AM
jmargush
I've seen where the fan is displaced from in... Mar 16 2025, 09:04 AM GregAmy
I've seen where the fan is displaced from int... Mar 16 2025, 08:33 AM mjrrti
Has anyone experienced the mark on the fan being ... Mar 16 2025, 08:20 AM bkrantz
Has anyone experienced the mark on the fan being... Mar 17 2025, 07:07 PM technicalninja Depending on year/application the fans are marked ... Mar 16 2025, 12:11 PM GregAmy See if this helps.
http://www.914world.com/bbs2/i... Mar 16 2025, 12:36 PM 930cabman
See if this helps.
http://www.914world.com/bbs2/... Mar 16 2025, 12:47 PM GregAmy
I just checked it with a dowel again.
You can... Mar 16 2025, 04:46 PM ClayPerrine Please don't use a chopstick........ :lol4:... Mar 17 2025, 03:32 PM emerygt350 Or just don't be an idiot. You guys all have ... Mar 17 2025, 03:52 PM JamesM
Or just don't be an idiot. You guys all have... Mar 17 2025, 11:54 PM emerygt350 That is a very pretty engine you got there. Mar 18 2025, 05:20 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 20th July 2025 - 12:58 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.