Look @ what popped up on NZ auction site, needs a lot of work but certainly some potential ?? Options

[porschetub]

1970 model as that was supplied by seller with VIN number ,checks out.
Semi setup for 350 Chevy but not much to work with...should you proceed that way ?,
930 wheels , and front end conversion also from that model ,stock rear brakes , trans supplied (901 tailshift ) matted to the Chevy .
Key points from the seller were rather sparse;
Rusty in places but not real bad (opinion) in this case,
steel flares on but only tacked on with spot welds ,hard to see that from pic ,
not one pic of the underside ,but the interior floor looked ok under all the mess.
was supplied with a heap of parts ,many from a second car parted out,
Chevy is apparently unknown history but and presents well ,
no rego in my country so a real hassle ,
front panel chewed up with holes !! .
Only for the distant and freight cost for in-op I might have has keen.
Comments would be interesting ,this car sold for $3510 NZD .

[gereed75]

Wheels look nice and worth a portion of the ask. Same with flairs

The long fabrication in the passenger well right front scares me. Much potential for bad f**kery there

Big time suck project anyway you look at it.

[Spoke]

Wheels look nice and worth a portion of the ask. Same with flairs

The long fabrication in the passenger well right front scares me. Much potential for bad f**kery there

Big time suck project anyway you look at it.

Agree with the wheels. 930 wheels are 7in and 9in. The rears don't look like 9in but the picture may be misleading. $500/wheel makes the purchase worth the price.

The passenger wheel well work might be for coolant lines for the V8.