 Wheel bearing washer test question, How easy should it move? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| emerygt350 |
 Jun 16 2025, 05:56 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,955 Joined: 20-July 21 From: Upstate, NY Member No.: 25,740 Region Association: North East States  |
Just curious. I did my fronts last week and rechecked them today. How easily should the washer move? I can make it move easily when I pry against the side of the hub with a screw driver. Is that right or should it be easy to move without prying? And does it really matter that much? I am from the old school "tighten til it's hard to rotate and the back it off half a turn" world.
|
   |
 
|
  |
Replies
| 930cabman |
Jun 18 2025, 12:10 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 4,147 Joined: 12-November 20 From: Buffalo Member No.: 24,877 Region Association: North East States 
|
"pushed easily" is the key phrase here.
Definitely better loose than tight |
|
|
|
Posts in this topic
emerygt350 Wheel bearing washer test question Jun 16 2025, 05:56 PM
SirAndy Here's my method:
- Tighten by hand until i c... Jun 16 2025, 06:13 PM
emerygt350
Here's my method:
- Tighten by hand until i ... Jun 16 2025, 06:41 PM Superhawk996 Do not pry to move the washer.
As a general rul... Jun 16 2025, 07:03 PM emerygt350
Do not pry to move the washer.
As a general ru... Jun 16 2025, 07:30 PM Superhawk996 Gonna put this up for additional guidance.
[ur... Jun 16 2025, 07:31 PM SirAndy
Gonna put this up for additional guidance.
Yupp,... Jun 16 2025, 07:51 PM Superhawk996
Gonna put this up for additional guidance.
Yupp... Jun 16 2025, 08:07 PM rjames "loosen clamping nut until the tab washer can... Jun 17 2025, 12:07 AM emerygt350 I went back in yesterday and loosened them till I ... Jun 18 2025, 02:23 PM SirAndy
I went back in yesterday and loosened them till I... Jun 18 2025, 03:09 PM emerygt350
I went back in yesterday and loosened them till ... Jun 18 2025, 03:55 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th June 2025 - 01:01 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.