FS: 1970 Roller $750 OBO Options

[didenpx]

For sale is a 1970 roller with cut fenders and stripped; I bought it in a lot and don't have any use for it. It was stored inside until last fall, was out in the elements with poor tarp coverage over the winter, and I have it under a car cover to save it until adoption.

It's a very solid shell with little rust except the jack points in the longs. The floors are solid, the longs forward of the jack points and underneath to the floor pan are are solid, the trunk and frunk floors are solid, the nose panel is solid, the corners of the tub in the front wheel well are solid, the rear firewall is solid.

The hell hole will need some attention; the battery tray is non existent and there are two quarter sized hole beneath them on the top of the long but the jacking point underneath is solid and the bottom of the long looks good.

It's too solid to scrap but I want it gone before the snow falls.

I'm hoping someone will save it as the basis for a track car etc. If you have a parts donor car with rust issues but good quarters this could be a great basis to build on.

I have it listed locally on Craigslist and have dozens of additional detailed photos of all of the typical rust areas that I'm familiar with (which are solid on this shell).

It comes on a set of later star wheels; the Fuchs in the picture are NOT included and are listed for sale separately.

Asking $750.00 or best offer. Located near Nashua NH.