 Fresh air blower fan |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| partwerks |
 Aug 5 2025, 06:57 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,642 Joined: 7-September 06 From: Grand Island, NE Member No.: 6,787  |
Car had been sitting for a couple years, but last I recall, the fresh air blower fan worked, but now, the light comes on, but fan is not working?
Any thoughts, ideas, or suggestions? |
   |
 
|
  |
Replies
| jim_hoyland |
Aug 5 2025, 08:44 PM
Post
#2
|
|
Get that VIN ? Group: Members Posts: 10,104 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California 
|
Here’s the fans inputs. Red is 12v, the other three are ground that you activate at the vent control. Do you have 12 V ?
Attached image(s) 
|
|
|
|
| DRPHIL914 |
Aug 11 2025, 07:46 AM
Post
#3
|
|
Dr. Phil Group: Members Posts: 5,955 Joined: 9-December 09 From: Kennesaw, GA Member No.: 11,106 Region Association: South East States
|
QUOTE(jim_hoyland @ Aug 5 2025, 10:44 PM)  Here’s the fans inputs. Red is 12v, the other three are ground that you activate at the vent control. Do you have 12 V ? i have seen these wires put back in by a previous owner incorrectly so it was only working on the middle setting, and would not work low or high, but if left in that position with pop the fuse too. sliders needed to be cleaned but the problem was mainly the wiring being crossed so make sure those are in the right place as well as cleaning your contacts etc. - new fan motors and assembly are available if you are taking it out i would strongly suggest you get a new motor and fan you will have the box apart to put in new seals anyway. My fan works better than new now. Phil |
|
|
|
Posts in this topic
partwerks Fresh air blower fan Aug 5 2025, 06:57 PM
jim_hoyland The light is not wired directly to the fan. The li... Aug 5 2025, 07:04 PM Jgilliam914 Cleaning the contacts on the sliders worked for me... Aug 5 2025, 07:30 PM
partwerks
Cleaning the contacts on the sliders worked for m... Aug 5 2025, 08:02 PM dtmehall not to rain on your parade....it could be the moto... Aug 5 2025, 08:06 PM partwerks
Here’s the fans inputs. Red is 12v, the other t... Aug 5 2025, 09:24 PM jim_hoyland IIRC , the plug attaches to the bottom of the blow... Aug 6 2025, 05:34 AM RiqueMar I know it probably sounds silly, though check the ... Aug 6 2025, 01:31 PM jim_hoyland Check the fuse # 8; it powers the cig lighter, fre... Aug 6 2025, 04:00 PM partwerks Tried a different relay also, but didn't work,... Aug 7 2025, 07:12 PM Dave_Darling Sounds like the contacts in the sliders.
--DD Aug 7 2025, 11:16 PM jim_hoyland Definitely a slider issue; see if you can reach in... Aug 8 2025, 05:49 PM RBR53 I just did this earlier today. Remove the ash tray... Aug 8 2025, 07:53 PM Steve Doesn’t help that it’s below the ash tray. Wh... Aug 8 2025, 10:46 PM jim_hoyland Check these connections. Mine had a tendency to sl... Aug 9 2025, 08:58 AM jim_hoyland @Dr. Phil
Who sells the replacement fan motors. ? Aug 11 2025, 12:55 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th July 2026 - 07:59 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.