 cylinder head temp gauge, sensor removal |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| EJP914 |
 Aug 17 2025, 12:44 PM
Post
#1
|
|
Member  Group: Members Posts: 279 Joined: 14-June 03 From: Monroeville, PA Member No.: 821  |
How to get this out? Wires broken at the under spark plug loop.
Guess I could just cut it and pull it out, but how do I get the new one in? If I loosen a bunch of the screws that hold the engine tin on, would that get me enough space to get the new sensor to the spark plug? OR is there some better way to do this? Thanks for the advice. Ed  |
   |
 
|
  |
Replies
| brant |
Aug 17 2025, 01:36 PM
Post
#2
|
|
914 Wizard Group: Members Posts: 12,041 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains 
|
Get a harbor freight 3 inch extension for 3/8 drive
Grind one corner off for the wire to stick through Deep 13mm socket And you can use this tool for removal/installation No need to take the tin work off this way |
 |
|
Posts in this topic
EJP914 cylinder head temp gauge Aug 17 2025, 12:44 PM
EJP914 Thinking about this, can I cut off the loop, bare ... Aug 17 2025, 04:45 PM EJP914 Just for clarification, this is NOT the cylinder h... Aug 17 2025, 04:50 PM Montreal914 Then this is a different story. That sensor is mos... Aug 17 2025, 05:03 PM brant My mistake then on the tool
You have to buy new
C... Aug 17 2025, 06:27 PM jim_hoyland Will a 6’ long cable reach the dash ? Aug 18 2025, 06:27 PM flxzcat Note that your Ring Terminal ID should be 14mm. No... Aug 20 2025, 05:31 PM 914werke
Note that your Ring Terminal ID should be 14mm.
... Aug 20 2025, 11:16 PM Montreal914 By the time you route it, I highly doubt 6’ will... Aug 21 2025, 06:56 AM Olympic 914 you could just run the wire down through the same ... Aug 21 2025, 08:59 AM
Ron914 What is that wire w/plug coming out of the tin jus... Aug 21 2025, 07:47 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd August 2025 - 08:08 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.