 Wire Routing, From the brake master |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| NARP74 |
 Aug 20 2025, 01:39 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,411 Joined: 29-July 20 From: Colorado, USA, Earth Member No.: 24,549 Region Association: Rocky Mountains  |
I am trying to find where the opening is in the cabin from where the cable from the brake cylinder goes. Underneath, by the steering rack, at the grommet, it goes into the cabin. I can't find it from the cabin side. I fed a guide wire through from underneath, it feels like it hits something. From the cabin side it looks like a metal channel is where that hole should be.
PO sprayed glue and put carpet over everything so I can't see what is going on. How do I get into that channel to run some wires? |
   |
 
|
  |
Replies
| NARP74 |
Aug 20 2025, 04:22 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,411 Joined: 29-July 20 From: Colorado, USA, Earth Member No.: 24,549 Region Association: Rocky Mountains |
Bummer, so what could be a route from the fuse panel area to the MC area? I need to get power and ground to the fuel pump, it is under the steering rack.
|
|
|
|
| IronHillRestorations |
Aug 20 2025, 05:45 PM
Post
#3
|
|
I. I. R. C. Group: Members Posts: 6,851 Joined: 18-March 03 From: West TN Member No.: 439 Region Association: None 
|
QUOTE(NARP74 @ Aug 20 2025, 02:22 PM)  Bummer, so what could be a route from the fuse panel area to the MC area? I need to get power and ground to the fuel pump, it is under the steering rack. You can sneak a wire through the grommet where the harness goes into the front trunk. It’s tedious but it can be done. Dish soap helps. You can tuck it under the wire bundle to hide it, and route it under the tank to the pump. I would sleeve it with heavy duty heat shrink or black pvc wiring tubing. Make sure the wire isn’t pinched or rubbing anywhere. Scratch off some paint and ground it to the body in a discrete location near the pump |
 |
|
Posts in this topic
NARP74 Wire Routing Aug 20 2025, 01:39 PM
IronHillRestorations
I am trying to find where the opening is in the c... Aug 20 2025, 04:17 PM
NARP74 I started fishing a heavy gauge wire around the ta... Aug 21 2025, 08:59 AM
JeffBowlsby "I need to get power and ground to the fuel p... Aug 21 2025, 09:34 AM |
2 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
1 Members: SO.O.C914er
|
Lo-Fi Version | Time is now: 21st August 2025 - 10:21 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.