 Shift rod linkage cover, How hard is it to change out |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Thunderchief |
 Sep 1 2025, 11:17 AM
Post
#1
|
|
Member  Group: Members Posts: 182 Joined: 12-August 19 From: Pasadena, CA. Member No.: 23,365 Region Association: Southern California  |
My shift rod linkage cover has a crack and is leaking. It looks like I'll have to disconnect the rear linkage to change it out? Is that difficult to do? Also, which lubricant and how much do I use when I do? Thanks as always.
|
   |
 
|
  |
Replies
| dr914@autoatlanta.com |
Sep 2 2025, 01:41 PM
Post
#2
|
|
914 Guru Group: Members Posts: 8,204 Joined: 3-January 07 From: atlanta georgia Member No.: 7,418 Region Association: None |
nothing to it, just remove the two set screws after rolling the cover onto the rod and pull out the rear shift bar and then replace the shift shaft seal, plenty on the shelf, and might as well replace the crown bushing and shift cup bushing while you are doing it
QUOTE(Thunderchief @ Sep 1 2025, 10:17 AM)  My shift rod linkage cover has a crack and is leaking. It looks like I'll have to disconnect the rear linkage to change it out? Is that difficult to do? Also, which lubricant and how much do I use when I do? Thanks as always. |
|
|
|
Posts in this topic
Thunderchief Shift rod linkage cover Sep 1 2025, 11:17 AM
bdstone914
My shift rod linkage cover has a crack and is lea... Sep 1 2025, 11:21 AM Thunderchief Side shift Sep 1 2025, 11:36 AM 914werke Not difficult, loosen the band & pull the cove... Sep 1 2025, 11:49 AM Thunderchief Great. There actually is. How hard is that to chan... Sep 1 2025, 03:43 PM Chad911sc Not too difficult. Need to remove the shift arm of... Sep 1 2025, 05:51 PM 914werke Umm no.
The best way to replace the seal is to pu... Sep 1 2025, 06:20 PM Stratfink I had the same issue and replaced the seal and cov... Sep 1 2025, 08:55 PM Thunderchief Wow! This is very helpful, thank you very much... Sep 1 2025, 09:05 PM FlacaProductions Is there any adjustment needed after reinstalling ... Sep 2 2025, 08:09 AM Montreal914 The only adjustment on a side shift linkage is whe... Sep 2 2025, 12:48 PM
jfort Mark with a paint pen where/how it all fits togeth... Sep 2 2025, 08:57 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd September 2025 - 05:46 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.