 MPS mounting rubber feet, Need to replace mine |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| chmillman |
 Sep 7 2025, 10:03 AM
Post
#1
|
|
Member  Group: Members Posts: 133 Joined: 15-June 24 From: Switzerland Member No.: 28,183 Region Association: Europe 
 |
Right now the MPS in my car is mounted with some sheet metal screws and old squished rubber grommets. Not at all the original mountings... Didn't see any suppliers for OE-style replacements anywhere near here, so I am looking at re-mounting it on some rubber standoffs like this:
 10mm in diameter, 10mm high, M4 threaded studs (Form "SS"). Three different Shore A hardnesses available, 40, 55 and 70. The same ones without the "necking down" in the middle are also possible:  The idea is to mount the standoffs to the body sheet metal and then be able to easily bolt/unbolt the MPS on the protruding studs with M4 locknuts and flat washers. What do you think? The mounting should be soft enough to damp out vibration but not so soft to allow the thing to shake significantly. |
   |
 
|
  |
Replies
| JeffBowlsby |
Sep 7 2025, 03:26 PM
Post
#2
|
|
914 Wiring Harnesses & Beekeeper Group: Members Posts: 9,035 Joined: 7-January 03 From: San Ramon CA Member No.: 104 Region Association: None
|
|
 |
|
Posts in this topic
chmillman MPS mounting rubber feet Sep 7 2025, 10:03 AM
Ishley McMaster Carr has rubber grommets that will work w... Sep 7 2025, 11:00 AM 914Sixer NEW ones are NOT available. Might be able to use ... Sep 7 2025, 11:31 AM JamesM Only real downside I have seen with using the stan... Sep 7 2025, 02:16 PM
chmillman
Only real downside I have seen with using the sta... Sep 7 2025, 02:22 PM chmillman
I wonder if these would work?
https://www.maxwar... Sep 8 2025, 03:15 AM FlacaProductions I'm looking for something on this as well. I ... Sep 8 2025, 07:42 AM chmillman
I'm looking for something on this as well. I... Sep 8 2025, 11:12 AM JeffBowlsby The original rubber grommet:
OD 16mm
ID 9mm
6mm T... Sep 8 2025, 05:04 PM chmillman
The original rubber grommet:
OD 16mm
ID 9mm
6mm ... Sep 9 2025, 01:19 AM JeffBowlsby Nice Mitch!
The groove diameter of the origin... Sep 9 2025, 08:10 AM 914Sixer Went to ACE hardware and went through all the bron... Sep 17 2025, 04:04 PM |
3 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
1 Members: sbsix
|
Lo-Fi Version | Time is now: 17th September 2025 - 08:37 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.