 I would like to make a shift knob, But I need a little help. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Shivers |
 Nov 8 2025, 05:49 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 3,170 Joined: 19-October 20 From: La Quinta, CA Member No.: 24,781 Region Association: Southern California  |
Would anyone know off the top of their head what the ID measurement is of the hole on the factory shift knob? I can not find mine right now to measure. Thanks you
 |
   |
 
|
  |
Replies
| bdstone914 |
Nov 8 2025, 06:41 AM
Post
#2
|
|
bdstone914 Group: Members Posts: 5,164 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
@Shivers
I can measure one later when I'm at the shop. Keep in mind the original knobs work with a crush sleeve. The shaft diameter of the shifter is13mm. I bet the shift know hole is 17mm |
 |
|
Posts in this topic
Shivers I would like to make a shift knob Nov 8 2025, 05:49 AM
sixnotfour 17mm :beer3: Nov 8 2025, 06:53 AM Shivers Thanks Guys. Nov 8 2025, 07:51 AM
Shivers RE: I would like to make a shift knob Nov 8 2025, 08:45 AM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th November 2025 - 11:10 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.