 Six rear brake dust shield question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| sixaddict |
 Nov 12 2025, 11:08 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 987 Joined: 22-January 09 From: Panama City Beach, FL Member No.: 9,961 Region Association: South East States 
 |
Are rear brake dust shields for six and four the same?
Painted or zinc plated? Seem to recall fronts are plated and rears painted but trying to verify. Thanks |
   |
 
|
  |
Replies
| sixaddict |
Nov 13 2025, 08:17 AM
Post
#2
|
|
Senior Member Group: Members Posts: 987 Joined: 22-January 09 From: Panama City Beach, FL Member No.: 9,961 Region Association: South East States
|
Dennis…Were you able to establish diameter of -6 part?
|
|
|
|
| DennisV |
Nov 13 2025, 08:25 AM
Post
#3
|
|
Senior Member Group: Members Posts: 773 Joined: 8-August 20 From: Santa Rosa, CA Member No.: 24,575 Region Association: Northern California
|
QUOTE(sixaddict @ Nov 13 2025, 06:17 AM)  Dennis…Were you able to establish diameter of -6 part? What I learned I put in the post in the parts vault: 901.352.801.201, Protective Plate - Disc brake rear 914-6 . It appeared to me the -6 was ~308 mm. I pulled that dust shield off our factory 914-6. That said, the car has some modifications so it's possible it was replaced at one time. I don't think so though. They fit the stock rotors quite well. They were very rough, so hard to tell what the original finish was. |
 |
|
Posts in this topic
sixaddict Six rear brake dust shield question Nov 12 2025, 11:08 PM
chmillman
Are rear brake dust shields for six and four the ... Nov 13 2025, 04:39 AM 914Sixer Painted rears Nov 13 2025, 06:45 AM
DennisV
Painted rears
Are you sure Mark? If so, please a... Nov 13 2025, 08:09 AM sixaddict Thank you……. Nov 13 2025, 07:06 AM davep I do recall a thread where this was discussed in d... Nov 13 2025, 08:50 AM 914Sixer I am not going to say I am even remotely correct. ... Nov 13 2025, 12:25 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 13th November 2025 - 05:33 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.