100 micron pre pump fuel filter, 75 front pump location Options

[rfinegan]

I am looking to route my fuel lines one more time (no kinks). While in there I will change my line to AN fittings and braided fuel lines. Does any one have a recommendation for a Pre fuel filter of 100 microns? I have a good post hi pressure filter in place already

Something like this?
https://www.summitracing.com/parts/sum-2301...OlOTtQ0t6Qf48Fc

[rfinegan]

Evil works fuel filter and 6-an lines
still more lines to make....

[JamesM]

I am assuming this is a fuel injected car? if not than YMMV, not sure what all the various carb pumps can accommodate.

[rfinegan]

I am assuming this is a fuel injected car? if not than YMMV, not sure what all the various carb pumps can accommodate.

Yes, This is a new Wabro pump and will be 2056 fuel injected too. I will post the spin on 10 micron filter pics under the battery tray/ fire wall to complete the system (ALL PTFE lines)unless i can find room under the tank too( keep out of the heat)?

Thanks for the tips

100 micron is like a large tank screen to catch the big chunks to protect the pump a little. The 10 micron will keep the injectors clean.

6-an =3/8 id PTFE, so should be larger inlet diameter and improvement and reduced bottlenecks kinks?