SPITTING CARB - 914-6 all stock, Need assistance - please see latest post to this thread Options

[ctc911ctc]

1970 - 914-6 All stock

Got the car off the rack after a 1 year clean up documented here:

http://www.914world.com/bbs2/index.php?sho...3371&st=100

- tightened the lugs, check one more time for leaks.......

Car started first try, backed out of the driveway and went around the block

Drive strong.....very strong......

#2 cyl-carb is still 'spitting' definitely not backfiring. Chasing this through my trusty guide:

https://www.performanceoriented.com/special-procedures-1

See "notes" section

Seems that when I performed the Lean Best Idle procedure #2 failed during the procedure......the diagnosis within the document states that either the path in that carb #2 is blocked or the jet is the wrong size - my bet is a clog......though the carbs were very clean when I got the car.

There is a little noise from the right side, that in a 914-2L 4Cyl would be considered quiet, my hope is that it is not valve noise and may be exhaust leaking......did I tighten the heater manifold small nuts????? dry.gif

Carb advice sought from those that have chased a SPITTING Carb

[Cairo94507]

I remember the 6's I've had that still has Webers. When starting them, cold, I would pump the gas pedal multiple times while cranking and it would fire. Typically took maybe 10 seconds. Once it fired, I would use the hand throttle to set the idle at about 1,500 RPM to let it warm up. (IMG:style_emoticons/default/beerchug.gif)