 Push Rod Tube Source, weeding out the Junk |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Jgilliam914 |
 Jan 4 2026, 12:48 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,374 Joined: 30-July 12 From: Iowa / Florida Member No.: 14,732 Region Association: Upper MidWest  |
The last few times I bought them they were through EMPI
very light gauge metal and I would consider junk. One even had a pin hole in them Where is a good place to source quality one? TIA |
   |
 
|
  |
Replies
| Craigers17 |
Jan 4 2026, 01:35 PM
Post
#2
|
|
Senior Member Group: Members Posts: 877 Joined: 5-August 17 From: Rome, GA Member No.: 21,317 Region Association: South East States 
|
The Type IV store sells billet aluminum, but they aren’t compatible with stock push rods. You have to use their chromoly push rods.
Here: https://lnengineering.com/ln-engineering-bi...-pushrod-tubes/ |
|
|
|
Posts in this topic
Jgilliam914 Push Rod Tube Source Jan 4 2026, 12:48 PM
mmichalik PMB has good push rod tubes as well: https://pmbp... Jan 4 2026, 03:43 PM bdstone914 I have replated originals for $60 a set what... Jan 4 2026, 04:05 PM
porschetub
I have replated originals for $60 a set wha... Jan 4 2026, 07:23 PM GregAmy I'm running Chris' stainless tubes and chr... Jan 4 2026, 06:07 PM Jack Standz
PMB has good push rod tubes as well: https://pmb... Jan 5 2026, 06:16 AM jim_hoyland Can the tubes and pushrods be replaced with motor ... Jan 6 2026, 05:53 PM TRP
Can the tubes and pushrods be replaced with motor... Jan 6 2026, 06:24 PM Jack Standz
Can the tubes and pushrods be replaced with motor... Jan 7 2026, 04:07 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th January 2026 - 10:30 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.