 Shift coupler question., (ok this is my 911 but I think it could be 914 relevant) |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| FlacaProductions |
 Feb 2 2026, 10:00 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,135 Joined: 24-November 17 From: LA Member No.: 21,628 Region Association: Southern California 
 |
Greetings - please move this if needed as it's not truly a 914 question but I think the general knowledge translates.
This is a pic of the shift coupler on my 67 911. am I incorrect in assuming the center pin should stretch across and fully seat inside both bushings? It actually looks like the center pin is too short as it's flush on one side but not the other. I was in there to adjust the throw as I'd like to not have to reach quite so far for 2nd and 4th when I saw it. I've only had this car since April so I'm still in the getting-to-know-you phase... Thanks! b  |
   |
 
|
  |
Replies
| 914Sixer |
Feb 2 2026, 11:09 AM
Post
#2
|
|
914 Guru Group: Members Posts: 9,401 Joined: 17-January 05 From: San Angelo Texas Member No.: 3,457 Region Association: Southwest Region
|
Yes TOO short. On a side bar note, looks like you have OVAL bushings, adding to sloppy shifting
|
 |
|
Posts in this topic
FlacaProductions Shift coupler question. Feb 2 2026, 10:00 AM
FlacaProductions Here's the other "flush" side.
Feb 2 2026, 10:01 AM
eradon This pin is not only to short, it is also to small... Feb 2 2026, 10:35 AM dr914@autoatlanta.com yes the one in there is too short
Greetings - ... Feb 2 2026, 11:40 AM FlacaProductions Ok. How would it be too short? Where would it have... Feb 2 2026, 02:29 PM |
7 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
|
Lo-Fi Version | Time is now: 2nd February 2026 - 03:16 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.