 Temporary oil pressure gauge |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TonyA |
 Feb 24 2026, 05:09 PM
Post
#1
|
|
Nachmal  Group: Members Posts: 651 Joined: 17-November 16 From: Hilltown PA Member No.: 20,596 Region Association: North East States 
 |
How can I set up a temporary oil pressure gauge and still have the idiot light work.
I think I would need to remove the oil pressure switch put in an adapter into the oil pressure port with a tee fitting for the gauge and the switch. What size fitting would i need to go into the case? Any suggestions on where i can buy? |
   |
 
|
  |
Replies
| frank_c |
Feb 24 2026, 05:37 PM
Post
#2
|
|
Member Group: Members Posts: 69 Joined: 29-December 24 From: Austin, TX Member No.: 28,542 Region Association: None |
For the flexible hose, you can use a 928 brake line - it has the correct M10x1 fittings on both ends. You will need to use a copper seal with it. I have the dual-pole sensor, and replaced the 1/8" NPT brass extension that the PO installed with this brake line, which I was able to fully thread it into the case unlike the 1/8" NPT fitting.
https://www.pelicanparts.com/search/?q=928-355-080-04-M4 |
|
|
|
Posts in this topic
TonyA Temporary oil pressure gauge Feb 24 2026, 05:09 PM
brant The case is 1.0 thread I believe by size 10
Also ... Feb 24 2026, 05:20 PM bkrantz I still don't like rubber lines in my pressuri... Feb 24 2026, 09:20 PM
dtmehall i guess the question that should be asked, is how ... Feb 24 2026, 09:50 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th February 2026 - 07:13 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.