 back up light connection at the switch in the transmission, how to reattach |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DRPHIL914 |
 Apr 29 2026, 08:44 AM
Post
#1
|
|
Dr. Phil  Group: Members Posts: 5,926 Joined: 9-December 09 From: Kennesaw, GA Member No.: 11,106 Region Association: South East States 
 |
When I removed the harness when pulling the motor I pulled one of the wires out of the small round end that the 2 wires use to push into the back up light switch, so the question is how do I put that wire back into the ball like end ? I tried using a crimper but it is out of shape and cant get pushed into the socket. im sure there is probably a special crimper to use that type of connector ?
Philip |
   |
 
|
Posts in this topic
Luke M
When I removed the harness when pulling the motor... Apr 29 2026, 09:00 AM
DRPHIL914
When I removed the harness when pulling the moto... Apr 29 2026, 09:06 AM
930cabman
When I removed the harness when pulling the moto... Apr 29 2026, 11:01 AM mgphoto
When I removed the harness when pulling the motor... Apr 29 2026, 09:08 AM jim_hoyland Be sure the pin is there… :) Apr 29 2026, 10:51 AM  |
|
Lo-Fi Version | Time is now: 29th April 2026 - 12:10 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.