 Valve Cover gaskets, Glue or grease ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jim_hoyland |
 Jun 17 2026, 07:28 AM
Post
#1
|
|
Get that VIN ?  Group: Members Posts: 10,088 Joined: 1-May 03 From: Sunset Beach, CA Member No.: 643 Region Association: Southern California 
 |
Should new valve cover gaskets be glued or set in a film of grease ?
Attached image(s) 
|
   |
 
|
  |
Replies
| brant |
Jun 17 2026, 11:03 AM
Post
#2
|
|
914 Wizard Group: Members Posts: 12,212 Joined: 30-December 02 From: Colorado Member No.: 47 Region Association: Rocky Mountains 
|
I put them in dry
Usually about 3 uses each gasket Just changed them and did valves yesterday Reused the dry gaskets Test drive this morning and no leaks |
 |
|
Posts in this topic
jim_hoyland Valve Cover gaskets Jun 17 2026, 07:28 AM
76-914 I didn't use either Jim. I did weld in some ta... Jun 17 2026, 07:30 AM VaccaRabite A THIN film of RTV on the valve cover side of the ... Jun 17 2026, 07:47 AM jim_hoyland Like this ? Jun 17 2026, 08:46 AM FlacaProductions I use gasketcinch on the cover side and some greas... Jun 17 2026, 08:52 AM rfinegan both
a little contact spay to hold to gasket to c... Jun 17 2026, 10:24 AM jim_hoyland :) Thanks. Jun 17 2026, 10:57 AM
930cabman
I put them in dry
Usually about 3 uses each gask... Jun 17 2026, 11:57 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2026 - 03:23 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.