 Potential Brake Failure?, Loss of brake pedal position |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rbzymek |
 Jul 23 2026, 02:14 PM
Post
#1
|
|
Member  Group: Members Posts: 203 Joined: 5-April 19 From: Northville, MI Member No.: 23,013 Region Association: Upper MidWest 
 |
I was hoping for some direction to correct a brake issue. While driving last week my right foot was resting on the brake pedal and then it started moving down! The brakes still worked but the pedal was way lower than design position. I pulled over immediately and had the car towed home. I installed a new master cylinder 7 years ago (about 13,000 miles) from 914Rubber (not uro). All four corners were rebuilt by PMB. New flex hoses and pads were also installed. Brakes have been working fine prior to this hiccup. Fluid resevior was full and no leaks detected.
So I suspect the M/C but are there any other possibilities? Thanks in advance! |
   |
 
|
  |
Replies
| Ninja |
Jul 24 2026, 10:29 AM
Post
#2
|
|
Member Group: Members Posts: 252 Joined: 25-September 25 From: Granbury Texas Member No.: 29,004 Region Association: Southwest Region |
Any aftermarket master cylinder is suspect...
914 rubber did not make the cylinders themselves (I believe). They subbed the work out. Try to find an ATE master. They have gotten expensive. I own an auto repair shop and I DON'T install anything but OEM master cylinders. If it's discontinued (happens a lot on 15+ year old cars) I decline the job now-a-days. |
|
|
|
Posts in this topic
rbzymek Potential Brake Failure? Jul 23 2026, 02:14 PM
bkrantz If truly no leaks and no fluid loss it might likel... Jul 23 2026, 07:48 PM emerygt350 The only other thing would be a sudden change in t... Jul 23 2026, 08:06 PM
rbzymek
The only other thing would be a sudden change in ... Jul 24 2026, 09:24 AM flipb The MC mounts to relatively thin metal that is kno... Jul 24 2026, 09:41 AM brant Did you pull the pedal board and then pull the rub... Jul 24 2026, 10:44 AM 914Sixer Sent PM Jul 24 2026, 01:59 PM fiacra Sounds like an MC internal seal failure. If you p... Jul 24 2026, 02:39 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th July 2026 - 12:23 AM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.