 what floor jack and engine lift plate should I get? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| scott_in_nh |
 Jul 27 2026, 07:21 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 812 Joined: 10-December 10 From: Hampton, NH Member No.: 12,471 Region Association: North East States  |
I'm trying to get everything together that I will need to finally drop the motor so I won't have any excuses left to keep kicking the can....
I need a new floor jack anyway, and I want to buy the Tangerine lifting plate. Any advantages/disadvantages of using the post model vs the Allen screw model? What size and type of jack? limited use so Harbor Freight models or similar are fine. What is the best height for dropping the motor? The car will be level unless there is a reason for it not to be. Thanks |
   |
 
|
  |
Replies
| TRP |
Jul 27 2026, 09:32 AM
Post
#2
|
|
Member Group: Members Posts: 422 Joined: 2-September 23 From: Morgan Hill, CA Member No.: 27,559 Region Association: None 
|
I have two of the Daytona jacks and the bolt through Tangerine plate. I have 1 blue and 1 gray Daytona, I wish I had the yellow, as I think it raises a little bit higher than the blue/gray ones. You want the taller jack so that you car reach the motor safely when the car is raised up in the air high enough to be able to slide the motor out.
You can sometimes time your purchase with one of the big sales and get a pretty good price on them. |
 |
|
Posts in this topic
scott_in_nh what floor jack and engine lift plate should I get? Jul 27 2026, 07:21 AM
Superhawk996 Tallest Daytona jack you can get and the tangerine... Jul 27 2026, 08:35 AM
930cabman
Tallest Daytona jack you can get and the tangerin... Jul 27 2026, 09:16 AM emerygt350 I always put the tires under the carr as well as t... Jul 27 2026, 10:23 AM johnhora Worth every $$ for doing this job....mak... Jul 27 2026, 10:31 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th July 2026 - 02:32 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.