 master cylinder reservoir lines |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bajafreaks |
 Oct 15 2026, 10:24 AM
Post
#1
|
|
Member  Group: Members Posts: 177 Joined: 7-February 14 From: Gardnerville, Nevada Member No.: 16,969 Region Association: Northern California  |
I'm in the middle of installing a new master cylinder, and yes its the job from hell.
My plastic reservoir lines are pretty brittle so I'm thinking I may replace them with rubber lines instead that are approved for brake fluid of course, it will probably make the overall MC install easier as well, at least I hope so. Anyone replaced their lines with all rubber? The size I believe is 9mm inside diameter, I'm finding 3/8" which 9.5mm. |
   |
 
|
  |
Replies
| bdstone914 |
Oct 15 2026, 10:41 AM
Post
#2
|
|
bdstone914 Group: Members Posts: 5,407 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
QUOTE(bajafreaks @ Oct 15 2026, 09:24 AM)  I'm in the middle of installing a new master cylinder, and yes its the job from hell. My plastic reservoir lines are pretty brittle so I'm thinking I may replace them with rubber lines instead that are approved for brake fluid of course, it will probably make the overall MC install easier as well, at least I hope so. Anyone replaced their lines with all rubber? The size I believe is 9mm inside diameter, I'm finding 3/8" which 9.5mm. Problem is finding lines of the same OD to fit the grometts that are in the sheet metal below the gas tank. Check with PMB |
|
|
|
Posts in this topic
bajafreaks master cylinder reservoir lines Oct 15 2026, 10:24 AM
Literati914 :popcorn: Oct 15 2026, 11:01 AM emerygt350 is your difficulty getting the grommets back into ... Oct 15 2026, 11:11 AM
bajafreaks
is your difficulty getting the grommets back into... Oct 15 2026, 01:12 PM fiacra
is your difficulty getting the grommets back int... Oct 15 2026, 01:38 PM bajafreaks
[quote name='bajafreaks' post='3275255' date='Oct... Oct 15 2026, 02:04 PM Shivers
I'm in the middle of installing a new master ... Oct 15 2026, 12:04 PM bajafreaks
[quote name='bajafreaks' post='3275240' date='Oct... Oct 15 2026, 01:13 PM Literati914
I'm pretty sure you had a thread about your M... Oct 15 2026, 03:45 PM |
11 User(s) are reading this topic (10 Guests and 0 Anonymous Users)
1 Members: doug_b_928
|
Lo-Fi Version | Time is now: 15th October 2026 - 05:41 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.