 Sloppy fit from the factory?, Engine Cooling Flaps |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Literati914 |
 Nov 4 2026, 03:14 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,407 Joined: 16-November 06 From: Dallas, TX Member No.: 7,222 Region Association: Southwest Region  |
So is the engine cooling flap that’s on the Driver’s side (L) just a sloppy fit when the engine is warm/hot and the thermostat is expanded? The pics below are representing my engine in that state and you can see a gap at the bottom and outside edge.
The passenger flap (not pictured) is sitting solidly covering the oil cooler with no gap under it (as should be). And as you can see from the picture, this side can not “close” anymore than it is, because it fouls the small vertical tin in front of cylinder 2. So maybe what I’m seeing is an engineered gap ?? Correct for the driver’s side or no? Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| mgphoto |
Nov 4 2026, 05:58 PM
Post
#2
|
|
"If there is a mistake it will find me" Group: Members Posts: 1,509 Joined: 1-April 09 From: Los Angeles, CA Member No.: 10,225 Region Association: Southern California |
I’ve found 2 engines that had this flap glued closed with double sided tape. Not sure it was factory but the tape was exactly the same.
|
|
|
|
Posts in this topic
Literati914 Sloppy fit from the factory? Nov 4 2026, 03:14 PM
Literati914 Here a shot from the fan shroud side looking towar... Nov 4 2026, 03:51 PM
porschetub
Here a shot from the fan shroud side looking towa... Nov 4 2026, 05:13 PM Superhawk996 Not correct Nov 4 2026, 06:42 PM |
7 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
|
Lo-Fi Version | Time is now: 4th November 2026 - 06:55 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.