Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Questions on installing rear sway bar brackets
seanpaulmc
post Nov 15 2026, 05:05 PM
Post #1


Member
**

Group: Members
Posts: 480
Joined: 6-December 16
From: Orlando, FL
Member No.: 20,649
Region Association: South East States



Hi World -

Looking for some advice from those who’ve gone before. TIA
I am beginning to plan installation of the rear sway bar brackets.

Attached Image

Attached Image

1. Should the bracket be bent to flatten against the trunk pan for welding? Same both sides of course.

I do not have the shock bolts in yet. One side is proving quite difficult to extract. I say this because of the next question.

2. Does the sway bar need to be mocked up (installed) to get alignment between each side, or is the alignment forgiving enough to eyeball?

Thank you
User is online!Profile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
bkrantz
post Nov 15 2026, 07:38 PM
Post #2


914 Guru
*****

Group: Members
Posts: 8,819
Joined: 3-August 19
From: SW Colorado
Member No.: 23,343
Region Association: Rocky Mountains



Here is a shot from underneath. When I cut out the rear floor I left the brackets attached to the cross member.


Attached thumbnail(s)
Attached Image
User is online!Profile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
5 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
3 Members: 913B, bkrantz, dtmehall

 



- Lo-Fi Version Time is now: 15th November 2026 - 07:57 PM
...